Onanon News

February 21, 2012

Onanon Integrates Electronic Components Into Connector Plugs

August 19 2011

Going Green- in our continued commitment to doing our part in saving our planet. Onanon has completely replaced all our old fluorescent lighting throughout our facility, to new energy efficient lighting.  Onanon’ commitment to going green will greatly reduce mercury entering the environment, greatly reduces greenhouse gas emissions and virtually eliminates PCB pollutions that would normally be polluting our environment. http://rightlights.org/

June, 2010

Expanding- Onanon has expanded its manufacturing operations into another 25,000sq foot facility, located in Milpitas CA. Complete with New product development design, automated pin insertion, SMT lines, high Tg insulator fabrication, clean rooms for medical connector assembly and an in-house tooling machine shop.

Febuary, 2010

Enviromental- Onanon has switched over to a more enviromentally friendly packaging material which is 100% recyclable, renewable and biodegradable and, on average, is made from 35% recycled paper.

December 2009

Onanon, Inc. exhibited their Custom Medical Connector Design and Manufacturing capabilities to the 3000+ attendees at the MD&M event BIOMEDevice on December 9-10, 2009. The exposition and executive forum took place in San Jose, CA at the McEnery Convention Center. This 3rd annual event for the Medical Device and Biopharma Development and Manufacturing industries was a very successful event for Onanon, as the attendees sought technological innovations and expanded design team resources.

September, 2009

Onanon, Inc. successfully achieved registration under the ISO 9001:2008 standards. ISO 9001:2008 specifies requirements for a quality management system where an organization needs to demonstrate its ability to consistently provide product that meets customer and applicable statutory and regulatory requirements, and aims to enhance customer satisfaction through the effective application of the system, including processes for continual improvement of the system and the assurance of conformity to customer and applicable statutory and regulatory requirements.

May 7th 2009

Onanon, Inc. to Exhibit at Design2Part Tradeshow