What we do:
News about Onanon highly automated design and manufacturing of custom connectors for OEMs.
June 14th-16th
Come Visit us at MD&M East Booth #1580
March and April 2016
Onanon Showcased in Wiring Harness News
Feb 9th 2016
Come Visit us at MD&M West Booth #367
September 2015
Medical Device and Diagnostic Industry – Onanon:
Automated Fine Wire Termination Simplifies Complex Medical Connector Assembly
May 20, 2015
Onanon Robo Hot Socket Slashes Complex Cable to Connector Assembly Time and Cost
February 9, 2014
March 1, 2013
Onanon earns recognition as a John Deere “Partner-level Supplier”
August 2012
Medical Device and Diagnostic Industry – Onanon:
Rapid Wire Termination Technology in Complex Connectors
February 21, 2012
Onanon Integrates Electronic Components Into Connector Plugs
March 2010
Medical Device and Diagnostic Industry – Onanon:
Mass Customization in Electrical Connector Design
January 2008
Industrial Maintenance & Plant Operations:
Onanon's diverse product line and highly automated process has allowed the company to expand technologically and easily adapt to RoHS.
August 19 2011
Going Green- in our continued commitment to doing our part in saving our planet. Onanon has completely replaced all our old fluorescent lighting throughout our facility, to new energy efficient lighting. Onanon’ commitment to going green will greatly reduce mercury entering the environment, greatly reduces greenhouse gas emissions and virtually eliminates PCB pollutions that would normally be polluting our environment. http://rightlights.org/
June, 2010
Expanding- Onanon has expanded its manufacturing operations into another 25,000 sq foot facility, located in Milpitas CA. Complete with New product development design, automated pin insertion, SMT lines, high Tg insulator fabrication, clean rooms for medical connector assembly and an in-house tooling machine shop.
Febuary, 2010
Environmental- Onanon has switched over to a more environmentally friendly packaging material which is 100% recyclable, renewable and biodegradable and, on average, is made from 35% recycled paper.
December 2009
Onanon, Inc. exhibited their Custom Medical Connector Design and Manufacturing capabilities to the 3000+ attendees at the MD&M event BIOMEDevice on December 9-10, 2009. The exposition and executive forum took place in San Jose, CA at the McEnery Convention Center. This 3rd annual event for the Medical Device and Biopharma Development and Manufacturing industries was a very successful event for Onanon, as the attendees sought technological innovations and expanded design team resources.
September, 2009
Onanon, Inc. successfully achieved registration under the ISO 9001:2008 standards. ISO 9001:2008 specifies requirements for a quality management system where an organization needs to demonstrate its ability to consistently provide product that meets customer and applicable statutory and regulatory requirements, and aims to enhance customer satisfaction through the effective application of the system, including processes for continual improvement of the system and the assurance of conformity to customer and applicable statutory and regulatory requirements.
May 7th 2009
Onanon, Inc. to Exhibit at Design2Part Tradeshow.